35mmdelux
Veni, vidi, vici
I live in the desert with no experience shooting in the snow. It is snowing right now, please advise adjustment needed when taking straight Leica M meter reading. add 2 stops? Thanks-
Ronald M
Veteran
Sun lighted snow filling meter area +2 for neg film +1.5 for trans or digi.
Overcast lighted snow filling meter area, plus 1 stop
Meter the palm of your hand, add a stop.
Never miss is an incident meter
Overcast lighted snow filling meter area, plus 1 stop
Meter the palm of your hand, add a stop.
Never miss is an incident meter
35mmdelux
Veni, vidi, vici
Thank you!
rdeleskie
Well-known
Do the same rules apply when using an incident meter?
Dave Wilkinson
Veteran
No....but it's even better to check the histogramDo the same rules apply when using an incident meter?
payasam
a.k.a. Mukul Dube
Ronald M spoke of a reflected light reading because the question was about a "straight Leica M meter reading". I used to add a stop to readings off my palm and 2.5 stops to readings off white paper or fabric. For snow, 2 stops is probably safer.
JoeV
Thin Air, Bright Sun
I live in the desert with no experience shooting in the snow. It is snowing right now, please advise adjustment needed when taking straight Leica M meter reading. add 2 stops? Thanks-
Why does the exposure compensation just have to be an aperture adjustment; why not adjust shutter speed instead? The title of this thread implies you can only use one method.
Incident metering may be better in this situation, but for in-camera metering, just aim the camera at a middle gray subject for metering; this will render the middle gray tones near middle gray on film, and the snow portions of the negative should receive additional exposure. Or just add a coupla stops. With either aperture or shutter speed. Your choice, depending.
Getting back to the aperture/shutter speed adjustment, if it's a landscape image (as the subject suggests), maintaining adequate DOF may be more important than a fast shutter speed, if the subject is stationary; in which case I'd recommend keeping the aperture where it's at for adequate DOF and slow the shutter speed by several stops. Or the opposite for moving subjects.
~Joe
Share: