aterlecki
Established
Probably against my better judgement I'm going to have a go at RA-4 printing and I've just picked up a Nova Quad processor quite cheaply. Does anyone own one and know how to fill the Quad? There are two holes with warning signs saying they must be filled with water before turning on the heater but how high should they be filled? Does anyone have an instruction booklet they could scan for me?
Is RA-4 a 3-step process (dev, stop, bleach/fix)? I have a fourth slot and I see mention of print stabaliser/brightener so if that's a useful (albeit non-essential) further step then I may use the fourth slot for that.
Thanks,
Tony
Is RA-4 a 3-step process (dev, stop, bleach/fix)? I have a fourth slot and I see mention of print stabaliser/brightener so if that's a useful (albeit non-essential) further step then I may use the fourth slot for that.
Thanks,
Tony