Zorki 4 self timer lever snapped

A

AndyP73

Newbie
Local time
12:04 PM
Joined
Jan 8, 2022
Messages
3
I managed to bring an old Zorki 4 to life with a bit of maintenance, but in the process I managed to snap the self-timer lever off (thinking it was a RH thread, when it was a LH).

The camera is back together again now, and I am wondering what is the best way of getting a new lever in place. The remains of the old shaft will have to be drilled out I guess? Anyone done that without taking the camera apart?

All tips welcome.
 
I was going to say get some left-handed bits in reverse to drill it out and it should grab the shaft and back it out, but since it is a LH screw then regular RH drill bits should do the same thing in forward drive. Make sure to drill it with the camera body in a normal upright position so the chips won't fall into the camera.

PF
 
farlymac said:
I was going to say get some left-handed bits in reverse to drill it out and it should grab the shaft and back it out, but since it is a LH screw then regular RH drill bits should do the same thing in forward drive. Make sure to drill it with the camera body in a normal upright position so the chips won't fall into the camera.

PF
Click to expand...

That sounds like a plan - thanks.
 
You must log in or register to reply here.
Back
Top Bottom