furcafe
Veteran
The frame counter indicator arrow on my SP is a bit off (it currently points between the actual tick marks). Is moving the indicator a simple DIY job, or does it involve complicated surgery?
From looking @ the exterior, I was thinking that I could maybe loosen the 3 tiny side screws & then rotate the entire chrome cover that bears the indicator arrow, but have no idea what's on the inside & what could go wrong (nightmare vision of cover popping off & springs flying out, never to be seen again).
As always, thanks in advance for any advice.
From looking @ the exterior, I was thinking that I could maybe loosen the 3 tiny side screws & then rotate the entire chrome cover that bears the indicator arrow, but have no idea what's on the inside & what could go wrong (nightmare vision of cover popping off & springs flying out, never to be seen again).
As always, thanks in advance for any advice.
Last edited:
furcafe
Veteran
Thanks, Fred.
It's not too annoying. For all I know, it could have been deliberately shifted because it does line up when I look @ the counter when the camera is just below eye level (i.e., from the left, as opposed to looking straight down @ the dial). At this point, the issue is moot as I don't have any screwdrivers that are small enough, but it's good to know that it's an easy job.
It's not too annoying. For all I know, it could have been deliberately shifted because it does line up when I look @ the counter when the camera is just below eye level (i.e., from the left, as opposed to looking straight down @ the dial). At this point, the issue is moot as I don't have any screwdrivers that are small enough, but it's good to know that it's an easy job.