Mudman
Well-known
My viewfinder isn't matching up horizontally and vertically, the vertical is off by a fraction of an inch. Any easy way to adjust this?
Thanks,
Eric
Thanks,
Eric
Anyway to make vertical and horizontal RF match easily? FED 2
- Thread starter Mudman
- Start date
- Latest activity Latest activity:
- Replies 10
- Views 1K
Kim Coxon
Moderator
Adjust the lateral RF first using the screw behind the middle one (under the E in Fed). The take the outer bezel off the RF window and adjust the vertical alignment.
Kim
Kim
wolves3012
Veteran
Kim,Kim Coxon said:
Wrong way around - adjusting the vertical will also affect horizontal so it needs to be done first...
Kim Coxon
Moderator
😱 😱 😱 :bang:
Kim
Kim
tomaas
Member
vertical alignment
how can i take the outer bezel off...?... only the external ring
how can i take the outer bezel off...?... only the external ring
JasonC
Established
The silver round outer bezel just screws off. Then you need to turn the inner ring with 2 spanner notches for vertical alignment.
Jason.
Jason.
tomaas
Member
JasonC
Established
Tomass,
In your picture you have unscrewed the entire assembly. You need to get the silver ring off and screw the rest back on the camera.
Jason.
In your picture you have unscrewed the entire assembly. You need to get the silver ring off and screw the rest back on the camera.
Jason.
tomaas
Member
jason,
i can't do it!
what can i do to get only the silver ring?
tomaas
i can't do it!
what can i do to get only the silver ring?
tomaas
wolves3012
Veteran
Screw the whole thing back in, fairly tight. Then heat the ring with a domestic iron or by moving a pencil-flame blowtorch around it for a couple of seconds (be careful after of course!). You could also try soaking the threaded part in a penetrating oil for a few days: apply a tiny amount where the bezel meets the prism housing, with it removed as per the photo.tomaas said:
tomaas
Member
i have try... and i can't do it.
