Canonet GIII Distance Ring Setting - Help Please

R

ruben

Guest
After a test on a small Canonet, I need to reset the distance ring so that the end of it - infinity - will coincide with what the film plane shows.

The million dollars question is which are the screws (or single screw) controlling this setting.

Cheers,
Ruben
 
Last edited by a moderator:
Sorry for a little bit late reply: Three set screws (X10-170207 page 3 in repair manual) and the fourth bigger screw between them. Follow the instructions for focus helix disassembly to get there, not exactly an easy and straightforward task.

Hope this helps.
 
You must log in or register to reply here.
Back
Top Bottom