Double X 5222 in HC110

[froyd]

First time developing this film/dev combo. I want to try D96 or even the df96 monobath but for now HC110 is what I have on hand.

The film was shot at ISO225.

Looking at the long thread on RFF and other resources online, I found:

• 
  1:60 dilution (H-ish) 10-11 minutes ..no temp mentioned (this comes from a Tom A. post)

• 1:31 dilution (B) 6mins at 20c

What's your process, and how do you handle agitation?

 

[davidnewtonguitars]

I'm using Tom A's numbers and it is working fine for me. I'm shooting XX at 200 to 400, same dilution and time.

 

[dourbalistar]

I haven't shot Double-X for a while now, but I've been using LegacyPro L110 for the last few years, which is a clone of HC-110. Looking back at my notes, I used:

• EI 200 - 1:31 at 68 degrees (20c) for 5.5 minutes
• EI 400 - 1:31 at 68 degrees (20c) for 6 minutes

Bog standard agitation scheme, 30 seconds initial, then 10 seconds every minute, using a Paterson Super System 4 tank. If it's helpful, you can see some of the results in an album on my Flickr.

 

[Phil_F_NM]

As mentioned above, standard agitation protocol.
My personal preference is dilution H. The negs I have gotten from 5222 using this scheme are very good for scanning as they are slightly flat but have detail across the range of tonality.

Phil Forrest

 

[Timmyjoe]

Haven't shot Double-X in a while, but from my notes I was shooting it at ISO 320, processing in HC-110 (the old formula, not sure if the new stuff is the same) at 64:1, 68ºF, for 16 minutes.

That combo scanned fairly well on my Nikon Coolscan.

Best,
-Tim

 

[froyd]

Haven't shot Double-X in a while, but from my notes I was shooting it at ISO 320, processing in HC-110 (the old formula, not sure if the new stuff is the same) at 64:1, 68ºF, for 16 minutes.

That combo scanned fairly well on my Nikon Coolscan.

Best,
-Tim

Interesting. Your times seem longer than what I've seen for the 320 rating (mostly 12-13 mins range at 68F). Do you do minimal agitation?

 

[froyd]

Phil, dourbalistar, David -- thanks for your suggestions!

 

[Timmyjoe]

One set of inversions every minute. I use Double-X with Nikon lenses from the late 1940's and early 1950's, they are low contrast lenses. If you're shooting Double-X with new Leica glass, which is considerably higher contrast glass, you'd want to use shorter development times.

Best,
-Tim

 

[madNbad]

This was exposed at ISO 125 with a yellow filter. The development time was 4 1/2 minutes at 20° C, agitations 5 seconds every 30 seconds:


Food Truck, Reveni Light Meter