drive blocked!

A

atlcruiser

Part Yeti
Local time
4:08 AM
Joined
Dec 8, 2009
Messages
1,183
Hi,
M8.......drive blocked error code. Looked inside and the shutter is still open, no meter stripe visable. Battery shows full charge but it is a used battery I just got. Battery was charged on my charger prior to test today. Took 4-5 shots with it, turned it off, turned back on and batt status still 100%. Tried to take nother shot and "whack" error codes "drive blocked" first comes up then a few seconds later "shutter fault" pops up.

Thoughts? I have had shutter fault once before and ended up giving it a good tap and it freed up.

Battery would be a guess but it shows fully charged.

Any knowledge on how to manually recock the shutter?
 
I would wait and call Leica on Monday and see if they have any advice. My best guess is that something is literally stuck in the shutter. A stray hair, some small grain of rock. There has to be something in there to get it jammed up. I can't imagine the battery being the cause. Worst case scenario is you'll have to send it away and there will be a bill.
 
Spoke with Tony at Popflash. Great guy and very helpful. He also thinks the batt is not the issue. I spoke with David at Leica in Jersey and his suggesstion was to send it in.

I am OK with the whole ordeal; it was used but in good shape from a good seller. Things will go wrong. And they wil get fixed.

It does really suck that I am looking at 6-8 weeks until I can get it back. Right now kicking over the idea of getting another then sellling this one once it is fixed with the 1 year warr from Leica. I have 2 trips planned int he enxt 2 months and I want an M8 with me.

I am going to recharge the 1st battery and see what happens. do not hold out much hope :)
 
Try this...it can do no harm

Try this...it can do no harm

  • Remove lens and memory card
  • Set shutter cocking to single exposure setting
  • Set the shutter speed dial on B
  • Hold shutter release down or use locking cable release
  • Turn power switch off
  • Insert fully charged battery
  • Turn power switch on-off-on
  • Release shutter or unlock cable release
Good luck!
 
kkdanamatt said:
  • Remove lens and memory card
  • Set shutter cocking to single exposure setting
  • Set the shutter speed dial on B
  • Hold shutter release down or use locking cable release
  • Turn power switch off
  • Insert fully charged battery
  • Turn power switch on-off-on
  • Release shutter or unlock cable release
Good luck!
Click to expand...
I did try...no luck.

I am about to admit defeat :bang:

I have a new, fully charged battery in it. I spent the last hour with bones and a grass skirt trying to get it to work. The monitor is on and I will let it sit until the battery dies then try the 2nd batt one last time.

thanks for the help

david
 
You must log in or register to reply here.
Back
Top Bottom