nick_
Newbie
Hello all. I'm new here, but have been stalking for quite a while. I recently got a Minolta Hi-Matic S that looked to be in super clean condition but had some issues, so I opened it up to take a look. I discovered the blue, black, and white wires were disconnected from the solder joint. This is a bit of a long shot, but I'm hoping someone can help me figure out which wire connects to which terminal so I can attempt to solder it back together. I am assuming the order should be red, green, blue, black, white - from left to right since that is what it is on the board feeding to this one. But, I don't want to make a vital error and then put batteries in and fry the board. Any help would be much appreciated!
