Petri 7S Lens Haze

Tom Harrell

Tom Harrell

Well-known
Local time
8:27 AM
Joined
Jun 12, 2005
Messages
339
I have a Petri 7s that has considerable haze inside! Looks to me like it near the rear lens. I can't figure out what kind of tool I need to unscrew the lens from the rear! I'm sure it must be a spanner of some time but where would I get such a tool? Also do I want to attempt it? The task might be to complicated for me! Anyone have ideas about doing such a thing?

Cheers,
Tom
 
Too bad, have you used the camera? I have one and I just looked at it, and it appears to be very hard to get to that haze unless it is on the exposed surface. I would run a roll though it to see how problem manifests itself.
 
John,
I made an attempt to clean it to no avail! I shined a light through it and believe it is internal! Perhaps I should take it to a repair shop and see if they can do the job!

Tom
 
John,
No, I have not run any film through it but if I did I venture to say that the haze would affect the pictures! Just how much they would be affected I cannot be sure! I may give it a shot and see what I get!

Thanks,
Tom
 
In fact here is one BEFORE the cleaning.

518685496_b79904d460.jpg
 
Golly John, that looks sharp to me! Cleaning improved on this? I just may run a roll through the camera and see what I get before I do anything!

Tom
 
Well, if you shot into the sun it was a different story. But to answer your question; it did not improve sharpness. If you look closely at the windows in my photo you can see what haze looks like.
 
You must log in or register to reply here.
Back
Top Bottom