merlin
Established
Hi folks - Just registered here after drinking-in lots of good info on Leica LTM's. What a treasure chest!
Thing is, I've just picked up a shiny-new Barnack O-serie (not really a thread-mount of course), and am learning it's weird and wonderful ways - like faithfully replacing the lens cap immediately after each exposure, remembering not to advance the film should I need to reset the shutter pin for the next frame (can't change it once the curtains are tensioned).
All fun, but the frame counter ring is totally unreliable.
When the slightest bit of downward pressure (down the shaft-line toward the body) is put on the winding knob during normal "human" winding, the counter ring stops rotating, then resumes whenever accidental downward pressure ceases. So I'm on #4, I'll wind and end up on #16, or #23, or whatever!
Is this a common quirk of all early LTM's, or is it something the Leica Service Elves should fix?
Appreciate your thoughts on this.
Thanks, Bruce
Thing is, I've just picked up a shiny-new Barnack O-serie (not really a thread-mount of course), and am learning it's weird and wonderful ways - like faithfully replacing the lens cap immediately after each exposure, remembering not to advance the film should I need to reset the shutter pin for the next frame (can't change it once the curtains are tensioned).
All fun, but the frame counter ring is totally unreliable.
When the slightest bit of downward pressure (down the shaft-line toward the body) is put on the winding knob during normal "human" winding, the counter ring stops rotating, then resumes whenever accidental downward pressure ceases. So I'm on #4, I'll wind and end up on #16, or #23, or whatever!
Is this a common quirk of all early LTM's, or is it something the Leica Service Elves should fix?
Appreciate your thoughts on this.
Thanks, Bruce
