where to find the tool?

I've tried the drawing compass route, and the stiff tweezers approach too. Both of those will twist too much to be useful, if the item in question is on there tightly.
 
I got it!!! Man that was the biggest pain in the butt. I was all worried about the levers and dials but had the hardest time with those screws. I did just what john neal suggested above. After all of the solvents didn't work I got out my soldering iron and heated them up. There actually isn't that much heat transfer to the screws. It was just enough to break them loose though. Now the top is off and the new POD goes in tonight. The old one was gone, nada, nothing at all. Not even the pile of goo I hear others talk about.

Thanks for all the help so far. I'll post some shots once its done.
 
You must log in or register to reply here.
Back
Top Bottom