shemp3
Newbie
I just recently bought my first Yashica Electro 35 GSN, and I am wanting to use a colored filter for black & white film, but I do not know how to set the camera to compensate for the filter. Any advice?
Yashica Electro 35 Using filters
- Thread starter shemp3
- Start date
- Latest activity Latest activity:
- Replies 5
- Views 2K
farlymac
PF McFarland
Look up "Filter Factor". I thought I had a site bookmarked, but it's not where I thought it should be.
PF
PF
ColSebastianMoran
( IRL Richard Karash )
Yes, "filter factor"... To do this on the GSN, you'll want to set the ASA dial to a number less than the number you would use for the given film without a filter.
farlymac
PF McFarland
Okay, I found it. The Yashica Guy has a downloadable users manual on his site that gives the filter factors in a chart. Very useful if you know the factor number of your filter, but some manufacturers don't always put it on the rim. You have to look them up on an information sheet that comes with the filter, or on a web site for that brand if you don't have the info sheet. A standard yellow filter is usually 1.5, so most all others will be the same. Unless it's a deep yellow, then it's a 2. I printed out the chart on card stock, then laminated it to keep in my camera bag.
PF
PF
shemp3
Newbie
Thank you, to all of you! Very helpful info
RBruceCR
Well-known
The Yashica Guy made a filter factor correction table located here: http://www.yashica-guy.com/document/qa.html
You would only have to ascertain the filter factor correction number from your manufacturer, which is normally enclosed in the leaflet inside the filter, or in Wikipedia with the name of your filter.
You would only have to ascertain the filter factor correction number from your manufacturer, which is normally enclosed in the leaflet inside the filter, or in Wikipedia with the name of your filter.
